![]() ![]() ![]() This option allows ProRemote to automatically reconnect to the last computer it was used with when it is opened. Enter the same password and press OK.Īfter entering your password, you will be asked if you want to save the connection. This is password you set in ProPresenter's Preferences. When you select a computer you will be prompted to enter a password to connect. If you have multiple computers or other versions of ProPresenter running, you will see additional options listed. Open ProRemote on your device and select the computer you want to connect to. Your computer and wireless device need to be on the same network in order to work. Now that you have enabled the remote settings in ProPresenter you can connect the app. The password can be anything you want to use. They can explore the app and select documents and playlists, but cannot cause anything to change in ProPresenter. "Observer" allows the person to see what's currently happening. "Controller" gives you or the person connected the ability to control ProPresenter from their iOS or Android device. This settings exists in each version, but is called "ProPresenter Remote Server" in earlier versions. You will then need to check the option for "Enable ProPresenter Remote" and the connection you want to make. This settings does not exist in ProPresenter 4 and ProPresenter 5. There is no reason to change these unless you have been instructed to do so by our support team. The Network Name and Port should be filled in automatically. In ProPresenter 6 you need to check the "Enable Network" option. Open Preferences and go to the Network settings. Screenshots are all from ProPresenter 6, but differences in ProPresenter 4 and ProPresenter 5 will be explained as needed.īefore you can connect ProRemote, you need to enable the connection in ProPresenter. Once connected, both methods work the same. This article will cover the standard connection first, then go over the Manual Connection option. Typically ProRemote discovers and communicates with your computer over Bonjour, but there are some technical limitations to this connection. ProRemote for Android only works with ProPresenter 6. This option will show any messages you show in OnSong to also appear on any connected ProPresenter stage displays.ProRemote for iOS can connect to ProPresenter 4 and newer over wifi. The playlist will contain found presentations that match the songs in the set using exact song title match. This option will automatically create playlists in ProPresenter when you select a set to view in OnSong. This is done using lyric matching technology. When you tap on a section in OnSong, this option will trigger the lyrics slide on the focused presentation. Songs must be imported into the ProPresenter library separately from OnSong. This will focus ProPresenter on the presentation that represents the current song based on song title match. This is where you can determine how you would like to remote-control OnSong. This will check to make sure the ProPresenter API is available and working before it shows as connected with a disconnect button. Once you've configured the network, you can connect to ProPresenter. Here is where you can type in the IP address and port that appears in the ProPresenter Network Preferences tab. This screen allows you to configure OnSong to send commands to ProPresenter 7 for remote control. ![]()
0 Comments
Leave a Reply. |